EasyManua.ls Logo

MerCruiser 3.0 MPI - Engine Oil; Checking and Filling

MerCruiser 3.0 MPI
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Section 5 - Maintenance
Page 54 90-899883272 MARCH 2008
Date Maintenance Performed Engine Hours
Engine Oil
Checking and Filling
NOTICE
Discharge of oil, coolant, or other engine/drive fluids into the environment is restricted by
law. Use caution not to spill oil, coolant, or other fluids into the environment when using
or servicing your boat. Be aware of the local restrictions governing the disposal or
recycling of waste, and contain and dispose of fluids as required.
IMPORTANT: Always use the dipstick to determine the exact quantity of oil or fluid required.
1. Stop the engine and allow the oil to drain into the oil pan for approximately five minutes
with the boat at rest in the water.
2. Remove the dipstick, wipe clean, and install fully into the dipstick tube. Wait 60 seconds
to allow trapped air to vent.

Table of Contents

Related product manuals