EasyManuals Logo

MerCruiser 350 Magnum MPI User Manual

MerCruiser 350 Magnum MPI
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #37 background imageLoading...
Page #37 background image
35
CC37
Checking Fluid Levels
CHECKING CRANKCASE OIL
1 Stop engine. Allow approximately five minutes for oil to drain into oil pan. Boat must be at rest in water.
2 Remove dipstick. Wipe clean and reinstall fully into dipstick tube.
3 Remove dipstick and observe oil level. Oil level must be between FULL and ADD. If oil level is below ADD:
4 Remove oil filler cap. Add specified oil to bring level up to, but not over, “FULL” mark on dipstick.
IMPORTANT: Do not overfill crankcase oil.
CHECKING TRANSMISSION FLUID
IMPORTANT: Engine must be run at 1500 RPM for 2 minutes immediately prior to checking level.
5 Borg-Warner Transmissions – Stop engine and quickly check fluid level by turning T-handle counterclockwise,
to remove dipstick. Fluid level should be up to full mark. If low, add specified fluid through dipstick tube on
Borg-Warner transmissions.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MerCruiser 350 Magnum MPI and is the answer not in the manual?

MerCruiser 350 Magnum MPI Specifications

General IconGeneral
BrandMerCruiser
Model350 Magnum MPI
CategoryEngine
LanguageEnglish

Related product manuals