OPERATION
35
In an emergency, if you cannot locate and correct the cause of the high
current draw, and you must operate the engine; perform the following:
1. Turn "OFF" or disconnect all accessories connected to the engine
and instrumentation wiring and reset the circuit breaker.
2. If the breaker remains open, electrical overload is still present.
Inspect the electrical system.
The power trim system is protected by a 10 amp fuse in the power trim
RED (Hot) wire.
a - 10 amp fuse
A 90 amp fuse is located on the starter.
a - 90 amp fuse
To Next Page
Loading...
Need help?
General
