OPERATION
37
2. Control shifting by moving the shorter control lever(s). This control
shifts the unit into gear with full lever movement. Move the lever
forward to engage the forward gear. Move lever backward to engage
reverse gear. Place the lever in the center position to shift to neutral.
Shifting should occur only with the engine at idle speed. Always
move to the desired gear position with a quick, firm motion. The
control handle should be adjusted by your dealer to engage forward,
reverse, and neutral when the lever is at the appropriate detent.
a
b
c
4090
a - Throttle control lever
b - Power trim switch
c - Shift control lever
3. See Power Trim section for detailed power trim operating
procedures.
Power Trim
Power Trim allows the operator to adjust the drive angle while underway
to provide the ideal boat angle for varying load and water conditions.
IMPORTANT: Each boat manufacturer has the option as to how the
power trim will function on their particular boat. The boat owner/operator
must be aware of how the power trim functions before operating the boat.
To Next Page
Loading...
Need help?
General
