MAINTENANCE
80
• Paint the drive unit and transom assembly with a good quality
marine paint or an anti‑fouling paint that does not contain copper,
tin, or any other material that could conduct electrical current. Do
not paint drain holes, anodes, or items specified by the boat
manufacturer.
3. Additional Corrosion Prevention Tips
• Spray the power package components on the inside of the boat
every two to three weeks with Corrosion Guard to protect the
finish from dulling and corrosion. External power package
components may also be sprayed.
Tube Ref No. Description Where Used Part No.
120
Corrosion Guard Power package
92-802878-5
5
• All lubrication points, especially the steering system and shift and
throttle linkages, should be kept well lubricated.
• Flush the cooling system after each use.
Battery
All lead acid batteries discharge when not in use. Recharge every 30 to
45 days, or when specific gravity drops below battery manufacturer's
specifications.
Refer to specific instructions and warnings accompanying your battery.
If this information is not available, observe the following:
To Next Page
Loading...
Need help?
General
