MAINTENANCE
52
Interval Task
Initial break‑in at 25 hours.
Lower Gear Housing Oil Filter and Oil ‑
Change the oil and filter.
Every 25 hours of operation or every
90 days, whichever occurs first.
Tie‑bar Mounting Bracket Nuts ‑ Inspect
and tighten to specifications as needed.
Propeller Shaft ‑ Lubricate
Propeller Nut ‑ Torque to specification.
Sterndrive ‑ Inspect, clean, and spray with
rust preventative.
Every 50 hours of operation or once
a season, whichever occurs first.
Perform 25 Hour Maintenance Items.
Sterndrive Unit Input Splines (Internal
and External) ‑ Lubricate with Optimol
Paste White T Grease.
Drive input shaft U‑joint crosses‑Inspect
and lubricate
Drive Mounting Nuts ‑ Tighten to
136 Nm (100 lb. ft.)
Saltwater Use: Every 50 hours or 60
days of operation, whichever occurs
first. Freshwater Use: Every 100
hours or 120 days of operation,
whichever occurs first.
Steering System ‑ Inspect for loose,
damaged or missing parts. Lubricate the
steering cylinder pivot points.
Every 100 hours of operation or once
a season, whichever occurs first.
Perform 25 and 50 Hour Maintenance
Items.
Drive Unit Bellows and Clamps ‑ Inspect
Lower Gear Housing Oil ‑ Change the oil.
Driveline Models ‑ Lubricate and inspect
the engine to transom driveshaft U‑joint
crosses and slip joint.
Steering head and remote control ‑
Inspect and lubricate
Every 200 hours of operation or at
re‑build.
Lower Gear Housing Oil Filter and Oil ‑
Change the oil and filter.
Every 200 hours of operation or once
a year, whichever occurs first.
Perform 25, 50, and 100 Hour
Maintenance Items.
Transom Input Shaft Bearing Housing
(Driveline Models Only) ‑ Change the oil.
To Next Page
Loading...
Need help?
General
