OUTBOARD INSTALLATION
130 eng
2. Position the fuel primer bulb so the arrow on the side of the
bulb is pointing up. Squeeze the fuel hose primer bulb until it
feels firm.
4. Within the first 10 seconds after the key switch has been
turned on, move the remote control handle from neutral into
forward gear 3 to 5 times. This will automatically start the
priming process.
NOTE: It may take a few minutes for the pump to complete the
priming process.
PURGING AIR FROM THE ENGINE MOUNTED OIL
RESERVOIR TANK
1. Loosen the vent cap on the engine mounted oil reservoir
tank.
2. Start the engine.
3. Operate the engine until all the air has vented out and oil
starts to flow out of the tank.
4. Tighten vent cap.
To Next Page
Loading...
Need help?
General
