MAINTENANCE
74 eng
b. Push rear of the cover down onto the rear pin and air
intake tube for the air compressor.
c. Insert vent hose into hole.
IMPORTANT: Make sure the flywheel cover is pushed down on
the air intake tube for the air compressor.
a - Front flange
b - Air intake tube
c - Vent hose
Fuel System
!
WARNING
Fuel is flammable and explosive. Ensure that the key switch is
off and the lanyard is positioned so that the engine cannot
start. Do not smoke or allow sources of spark or open flame in
the area while servicing. Keep the work area well ventilated
and avoid prolonged exposure to vapors. Always check for
leaks before attempting to start the engine, and wipe up any
spilled fuel immediately.
Before servicing any part of the fuel system, stop the engine and
disconnect the battery. Drain the fuel system completely. Use an
approved container to collect and store fuel. Wipe up any
spillage immediately. Material used to contain spillage must be
disposed of in an approved receptacle. Any fuel system service
must be performed in a well‑ventilated area. Inspect any
completed service work for sign of fuel leakage.
To Next Page
Loading...
Need help?
General
