Mercury 150 FourStroke - Steering Cable - Starboard Side Routed Cable; Steering Link Rod Fasteners (if Equipped)

Steering Cable ‑ Starboard Side Routed Cable
1. Lubricate O‑ring seal and entire cable end.
3724
95
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE O-ring seal and entire cable end 92-802859A 1
2. Insert steering cable into tilt tube.
3. Tighten the nut to the specified torque.
47708
Description
Nm lb‑in. lb‑ft
Nut 47.5 35
Steering Link Rod Fasteners (if equipped)
IMPORTANT: The steering link rod that connects the steering cable to the
engine must be fastened using a special washer head bolt ("a" ‑ Part Number
10‑856680) and self‑locking nylon insert locknuts ("c" and "d" ‑ Part Number
11‑826709113). These locknuts must never be replaced with common nuts
(nonlocking) as they will work loose and vibrate off, freeing the link rod to
disengage.
OUTBOARD INSTALLATION
eng 105