FEATURES AND CONTROLS
90 eng
10.Detent tension adjustment screw ‑ This screw can be
adjusted to increase or decrease the effort to move control
handle out of detent positions (cover must be removed).
Turning the screw clockwise will increase tension. Adjust to
tension desired.
a - Detent tension adjustment
screw
b - Control handle tension
adjustment screw
SYNCHRONIZING ENGINES
The auto synchronizing feature, when engaged, will
automatically adjust all engine speeds to match the speed of the
starboard engine.
Press the "SYNC" button on the CAN trackpad to turn auto
synchronization on or off. When the sync LED is yellow, the
"SYNC" button has been pressed, but the conditions are not right
for auto synchronization to engage. When the sync LED turns
red, engine synchronization has been engaged. The engines will
remain synchronized as long as engine speed is over 900 RPM
for two seconds, remote control handles are positioned within
10% of each other, and the engines are below 95% throttle
opening.
To disengage the auto synchronization feature, press the
"SYNC" button.
SYNC
1 LEVER
NEUTRAL
TROLL
THROTTLE
ONLY
DOCK
TRANSFER
+
-
22590
To Next Page
Loading...
Need help?
General