MAINTENANCE
eng 115
Installation
1. Lubricate the O‑ring seals with oil.
a - Filter
b - O‑ring seals
2. Install the fuel filter and tighten securely.
IMPORTANT: Visually inspect for fuel leakage from the filter
while squeezing the primer bulb until firm, forcing fuel into the
filter.
DRAINING WATER FROM THE FUEL FILTER CHAMBER
NOTE: If a sufficient amount of water has accumulated in the
fuel filter chamber, the warning system will turn on. Draining the
water from the fuel filter chamber is required.
1. Pull the drain hose off the right side fitting. Hold the open
end of the hose over a container.
2. Use a 1/8 in. hex wrench and loosen the drain screw and
drain the fuel filter chamber.
b
a
3388
To Next Page
Loading...
