FEATURES AND CONTROLS
eng 63
8. Throttle only/station select button ‑ Allows the boat operator
to increase engine RPM for warm‑up, without shifting the
engine into gear. To engage throttle only, move the control
handle into the neutral position. Press the throttle only
button while moving the control handle ahead to the forward
detent. The horn will sound once and the neutral light will
start flashing. The horn will sound twice when throttle only is
engaged. Advance throttle to increase engine RPM. To
disengage, return control handle to neutral position and
press the throttle only button. Engine RPM is limited to
prevent engine damage. Pressing the station select button
at an inactive helm initiates a helm transfer. Refer to Helm
Transfer.
a - Start/stop button
b - Throttle only/
station select
button
c - Neutral LED
d - Active LED
HELM TRANSFER
!
WARNING
Avoid serious injury or death from loss of boat control. The
boat operator should never leave the active station while
engine is in gear. Helm transfer should only be attempted while
both stations are manned. One‑person helm transfer should
only be performed while engine is in neutral.
NOTE: Idle position is preferred when doing a helm transfer. If
conditions do not allow the remote control to be placed at idle
position, a helm transfer can be done while in gear.
NOTE: The active light on the remote control will be illuminated
at the helm that is in control of the engine.
To Next Page
Loading...
Need help?
General