FEATURES AND CONTROLS
eng 85
If a failure should occur while underway which causes one of the
outer engines into forced neutral/idle condition, the center engine
will also be forced to neutral/idle. Operation to the center engine
can be restored by moving the control handle of the functioning
outer engine back into neutral and then reengaging.
QUAD ENGINE THROTTLE AND SHIFT OPERATION
Movement of the handles on the remote control allows the boat
operator to control the engine throttle speed and gear shift
positions of all four engines.
The throttle and shift function is dependent on what engines are
running. Refer to the following table.
Port Outer
Engine
Port
Inner
Engine
Starboard
Inner
Engine
Starboard
Outer
Engine
Control Handle
Function
Running Running Running Running
Port inner and outer
engines throttle and
shift = controlled by
port control handle
Starboard inner and
outer engines throttle
and shift = controlled by
starboard control
handle
Running Running Off Off
Port inner and outer
engine throttle and shift
= controlled by port
control handle
Off Off Running Running
Starboard inner and
outer engine throttle
and shift = controlled by
starboard control
handle
Off (ignition
key switch
turned on)
Running Running Running
Port inner engine
throttle and shift =
controlled by port
control handle
Running Running Running
Off (ignition
key switch
turned on)
Starboard inner engine
throttle and shift =
controlled by starboard
control handle
To Next Page
Loading...
Need help?
General