Description Nm lb. in. lb. ft.
Access cover bolt (3) 10 88
SHIFT CABLE INSTALLATION
!
WARNING
The shift cable must be adjusted to lock the reverse gate against
unexpected engagement (caused by water pressure) hitting the
gate while operating the boat in forward. Activation of the reverse
gate will cause sudden unexpected stopping of the boat. Sudden
stopping may cause occupants to be thrown within the boat or
even out of the boat. This action may result in serious injury or
death.
1. Attach the shift cable to the shift cam with a flat washer and a
self‑locking nylon insert locknut as shown. Tighten the locknut
against the flatwasher, then back‑off the locknut 1/4 turn.
2. Place the remote control handle into full forward position.
3. Adjust the shift cable adjustment barrel so that the roller is at
the full end of travel (bottom) in the shift cam.
To Next Page
Loading...
