a - Gasket b - Thread-in hose coupling
Top Cowl Removal And Installation
REMOVAL
1. Unlock the rear latch by pushing lever down.
INSTALLATION
1. Engage the front hook and push cowl back over the cowl seal.
2. Push cowl down and move the rear latch lever up to lock.
Corrosion Control Anode
Your outboard has a corrosion control anode installed on the gearcase. An anode helps protect the outboard
against galvanic corrosion by sacrificing its metal to be slowly corroded instead of the outboard metals.
The anode requires periodic inspection especially in salt water which will accelerate the erosion. To maintain this
corrosion protection, always replace the anode before it is completely eroded. Never paint or apply a protective
coating on the anode as this will reduce effectiveness of the anode.
To Next Page
Loading...
