INSTALLATION
1. Engage the front hook and push cowl back over the cowl seal.
2. Push cowl down and move the rear latch lever up to lock.
Corrosion Control Anode
Your outboard has a corrosion control anode installed on the gearcase. An
anode helps protect the outboard against galvanic corrosion by sacrificing its
metal to be slowly corroded instead of the outboard metals.
The anode requires periodic inspection especially in saltwater which will
accelerate the erosion. To maintain this corrosion protection, always replace
the anode before it is completely eroded. Never paint or apply a protective
coating on the anode as this will reduce effectiveness of the anode.
To Next Page
Loading...
