2. Remove the spark plug to inspect. Replace spark plug if electrode is worn
or the insulator is rough, cracked, broken, blistered or fouled.
Spark Plug
Spark plug gap 1.0 mm (0.040 in.)
4. Before installing spark plug, clean off any dirt on the spark plug seat.
Install plug finger tight, and then tighten 1/4 turn or torque to
specifications.
Description
Nm lb‑in. lb‑ft
Spark plug 27 – 20
Lubrication Points
1. Lubricate the following with Quicksilver or Mercury Precision Lubricants
2‑4‑C with PTFE.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE
Co-pilot threads, swivel bracket,
transom clamp screws, tiller handle
bushing, shift handle detent
92-802859A 1
• Co‑Pilot ‑ Lubricate threads.
MAINTENANCE
44 eng
To Next Page
Loading...
