EasyManuals Logo

Mercury 40 User Manual

Mercury 40
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
MAINTENANCE
77
Assemble steering link rod to engine with special washer head bolt,
locknut and spacer. First torque bolt to specifications, then torque
locknut to specifications.
3086
a
b
c
e
d
a - Special washer head bolt (10‑856680)
b - Nylon insert locknut (11‑826709113)
c - Spacer
d - Flat washers
e - Nylon insert locknut (11‑826709113)
Description Nm lb. in. lb. ft.
Special washer head bolt 27 20
Nylon insert locknut "b" 27 20
Nylon insert locknut "e" Tighten until seats, then back off 1/4 turn
Fuse Replacement ‑ Electric Start Models
IMPORTANT: Always carry spare SFE 20 amp fuses.
The electric starting circuit is protected from overload by an SFE
20 amp fuse. If the fuse is blown, the electric starter motor will not
operate. Try to locate and correct the cause of the overload. If the
cause is not found, the fuse may blow again.

Table of Contents

Other manuals for Mercury 40

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 40 and is the answer not in the manual?

Mercury 40 Specifications

General IconGeneral
Horsepower40 hp
Starting SystemElectric
SteeringRemote
Fuel Induction SystemEFI (Electronic Fuel Injection)
Shaft Length20"
Full Throttle RPM Range6000

Related product manuals