Mercury 60 FourStroke EFI Formula Race - Page 100

OUTBOARD INSTALLATION
92
a. Shift remote control into forward. The propeller shaft should
be locked in gear. If not, adjust the barrel closer to the cable
end guide.
b. Shift remote control into reverse while turning propeller.
The propeller shaft should be locked in gear. If not, adjust
the barrel away from the cable end guide. Repeat steps a
through c.
c. Shift remote control back to neutral. The propeller shaft
should turn freely without drag. If not, adjust the barrel
closer to the cable end guide. Repeat steps a through c.
THROTTLE CABLE INSTALLATION
Install the cables into the remote control following the instructions
provided with the remote control.
1. Position the remote control into neutral.
N
26838
2. Fit the throttle cable through the rubber grommet.
a
b
28491
a - Rubber grommet
b - Throttle cable
3. Attach the throttle cable to the throttle lever with a cotter pin
retainer.
4. Adjust cable barrel until the barrel slips onto the mounting
stud.