MAINTENANCE
57
2. Remove the spark plugs to inspect. Replace spark plug if
electrode is worn or the insulator is rough, cracked, broken,
blistered, or fouled.
Spark Plug
Spark plug gap 1.0 mm (0.040 in.)
4. Before installing spark plugs, clean off any dirt on the spark
plug seats. Install plugs finger‑tight, and then tighten 1/4 turn
or torque to specifications.
Description Nm lb. in. lb. ft.
Spark plug 27 20
Fuse Replacement
IMPORTANT: Always carry spare 20 amp fuses.
The electrical wiring circuits on the outboard are protected from
overload by fuses in the wiring. If a fuse is blown, try to locate and
correct the cause of the overload. If the cause is not found, the fuse
may blow again.
To Next Page
Loading...
