OUTBOARD INSTALLATION
80
NOTE: The inside holes on the transom reinforcement plate are
for the lower transom bolts and the outside holes are for the upper
transom bolts.
a - Large transom washer
b - Transom reinforcement plate
Description Part Number
Large transom washer 67‑896392
Transom reinforcement plate 67‑896305
FASTENING THE OUTBOARD TO THE TRANSOM
1. Install the outboard so that the anti‑ventilation plate is in‑line
or within 25 mm (1 in.) below the bottom of the boat.
a - Anti‑ventilation plate
b - 25 mm (1 in.)
2. Apply marine sealer to the shanks of bolts, not the threads.
3. Fasten the outboard with the provided mounting hardware.
Tighten the locknuts to the specified torque.
To Next Page
Loading...
