EasyManua.ls Logo

Mercury 700A - Chapter 6 Battery; 6.1 BATTERY PACK; 6.2 RECHARGING THE BATTERY PACK

Mercury 700A
102 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Model 700A User's Manual Battery
Information in this document is subject to change without notice!!! Page 6-1
Chapter 6 Battery
6.1 Battery Pack
Depending on model, included with the notebook is one high energy rechargeable
Lithium Ion (Li-Ion), or Nickel Metal Hydride (NiMH) battery pack. In general, a
fully charged battery pack can support around 2-3 hours of operation, with Power
Management option enabled. However, difference in configuration (CPU, HDD, Memory
etc.) and system utilization (especially I/O activities) can affect the operation time
greatly.
6.2 Recharging the Battery Pack
Your notebook supports both on-line and off-line recharge. Follow the procedure below
to recharge battery:
Make sure the battery pack is installed in the notebook.
Connect the AC Adapter to the notebook and to an electrical outlet.
When a battery pack is being recharged, its Battery Pack LED would be “ON”. For
detail on the LEDs, please refer to Chapter 2.3 and Chapter 2.4. While the notebook is
OFF, a depleted Li-Ion (NiMH) battery pack will take three hours (two hours) to
recharge.
6.3 Questions and Answers:
Q: I can feel the heat next to the TouchPad during recharge. Is it normal?
A: The battery will generate heat during recharging and discharging. There is
protection circuit inside the notebook to prevent overheating. User needs not to
worry.
Q: My battery operation time isn't as long as it should be. Why?

Table of Contents