Model 700A User's Manual Configuring Your System
Information in this document is subject to change without notice!!! Page 11-1
Chapter 11 Configuring Your System
11.1 Configuration Software
The notebook can easily be configured to suit your personal needs. The built-in SETUP
program allows you to setup standard and advanced parameters as well as the Power
Management Features. The information is stored in a battery-backed CMOS memory;
so when the power is turned off, your setup is retained. This Configuration Software is
sometimes refer to as CMOS Setup, BIOS Setup, or simply the SETUP.
Note: The SETUP can only be activated by pressing <F2> during system boot-up.
You are requested to perform the following one-time procedure immediately after you
have upgraded/reprogrammed your BIOS:
• Press <F2> during system boot-up to get into the SETUP.
• Choose Auto Configuration with Defaults.
• Press Enter, and then select “Y” followed by Enter.
• Choose Save Settings and Exit, then Enter.
• Answer “Y” followed by Enter.
• The system will boot-up automatically. Press <F2> during system boot-
up to get into the SETUP.
• Now, you can customize the BIOS for your personal needs.
For detail on the BIOS SETUP, read on.
Note: For information on the BIOS upgrade, contact your local notebook dealer.
To Next Page
Loading...