The ROM Drive Model 700A User's Manual
Page 8-2 Information in this document is subject to change without notice!!!
8.2 DISC Loading/Ejection
Disc Loading
• Press the Eject button on the front panel to release the disc tray.
• Gently pull the disc tray to its fullest extend.
• Place the disc on the tray with its labeled side facing up.
• Gently push the disc tray back into the drive.
Disc Ejection
• Press the Eject button on the front panel to release the disc tray.
• Gently pull the disc tray to its fullest extend.
• Remove the disc from the disc tray, and put it in its protective case.
• Gently push the disc tray back into the drive.
8.3 ROM Disc Maintenance
Disc Cleaning
When cleaning the disc, be sure to wipe it from center to edge. Don’t wipe the disc in a
clockwise/counter clockwise direction. Otherwise, this can damage the disc. Keep the
discs away from high temperature and high pressure.
Disc Handing
When removing a disc from its protective case or
loading a disc to a drive, hold it by its edges as
shown in figure below. NEVER touch the disc’s
data surface (non labeled side.)
To protect the disc against scratches and dirt,
keep it in its protective case when not in use.
To Next Page
Loading...