OUTBOARD INSTALLATION
118 eng
4. Push in on the shift cable end until resistance is felt. Adjust
the cable barrel to attain distance measured in Step 3.
a - Shift cable end
b - Cable barrel
5. Place the cable barrel into the pocket. Fasten the cable with
locknut and flat washer.
a - Cable barrel
b - Locknut
c - Flat washer
6. Check shift cable adjustments as follows:
a. Shift the remote control into forward. The propeller shaft
should be locked in gear. If not, adjust the barrel closer to
the cable end.
To Next Page
Loading...
