EasyManuals Logo

Mercury 9.9 User Manual

Mercury 9.9
153 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #98 background imageLoading...
Page #98 background image
OPERATION
86 eng
3. Set the lanyard stop switch to "RUN" position. Refer to
General Information ‑ Lanyard Stop Switch.
19791
4. Set the remote control handle to neutral position.
IMPORTANT: Avoid engine flooding ‑ Do not advance the
throttle while engine is not running. This will inject fuel into the
engine and may cause a hard starting flooded condition.
N
26838
IMPORTANT: Outboards with battery charging capabilities must
not be operated with battery cables disconnected from the
battery. Damage to the charging system may result.
5. Do not use the throttle‑only feature on the remote control for
initial starting. After starting the engine, you can slowly
advance the throttle‑only lever, or press the throttle‑only
button and advance the control handle, to increase idle
speed until the engine is warmed up. Keep engine speed
below 2000 RPM.
27242

Table of Contents

Other manuals for Mercury 9.9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury 9.9 and is the answer not in the manual?

Mercury 9.9 Specifications

General IconGeneral
Cylinders2
Fuel TankExternal
Full Throttle RPM Range5000 - 6000 RPM
Fuel Induction SystemCarbureted
Alternator Amp6 amp
Horsepower9.9 hp
StartingManual
Shaft Length15 in, 20 in
SteeringTiller

Related product manuals