95
CD816
Power Package Layup (Continued)
Dealer should perform the remaining tasks prior to layup:
12After draining, perform all checks, inspections, lubrication and fluid changes outlined in Maintenance
Schedules.
CAUTION
If boat is to remain in the water, seacock, if so equipped, must remain closed until engine is to be re-
started to prevent water from flowing back into seawater cooling system. If boat is not fitted with a sea-
cock, water inlet hose must be disconnected and plugged to prevent water from flowing into cooling
system and/or boat.
13Close seacock, if so equipped, or disconnect and plug seawater inlet hose, if boat is to remain in the water.
14Clean seawater strainer, if equipped. Refer to Cleaning Quicksilver Seawater Strainer.
15Clean engine and coat with Quicksilver Corrosion Guard.
16Lubricate all cables and linkages.
17Remove and store battery in a cool, dry place. Do not store on a concrete surface, or on the ground. Place
on a dry, wood board or a thick plastic base (Refer to battery manufacturer’s instructions.)
CD72
CAUTION
Stern drive unit should be stored in full “down” position. Universal Joint bellows may develop a “set”
if unit is stored in raised position and may fail when unit is returned to service.
18Place stern drive unit in the full DOWN / IN position.
To Next Page
Loading...
