Section 6 - Storage
90-899883173 DECEMBER 2007 Page 95
Battery Storage
Whenever the battery will be stored for an extended period of time, be sure the cells are
full of water and the battery is fully charged and in good operating condition. It should be
clean and free of leaks. Follow the battery manufacturer's instructions for storage.
Power Package Recommissioning
1. Ensure that all cooling system hoses are connected properly and hose clamps are tight.
!
CAUTION
Disconnecting or connecting the battery cables in the incorrect order can cause injury
from electrical shock or can damage the electrical system. Always disconnect the
negative (‑) battery cable first and connect it last.
2. Install a fully charged battery. Clean the battery cable clamps and terminals and
reconnect cables. Tighten each cable clamp securely when connecting.
3. Coat the terminal connections with a battery terminal anti‑corrosion agent.
4. Perform all the checks in the before starting column of the Operation Chart.
NOTICE
Without sufficient cooling water, the engine, the water pump, and other components will
overheat and suffer damage. Provide a sufficient supply of water to the water inlets during
operation.
5. Start the engine and closely observe instrumentation to ensure that all systems are
functioning correctly.
6. Carefully inspect the engine for fuel, oil, fluid, water and exhaust leaks.
7. Inspect the steering system, shift and throttle control for proper operation.
To Next Page
Loading...
