SEAWATER COOLED MODELS
SERVICE MANUAL NUMBER 23
90-861326--1 MARCH 1999 Page 6A-17
4. Pack bearings and cavity between bearings with Shell Alvania No. 2 Grease or substi-
tute. Slide bearings and shaft into bearing housing bore and install snap ring.
72661
a
a-Shaft With Bearings
72658
a
a-Snap Ring
5. Apply a thin coat of Loctite 27131 to outside diameter of new bearing housing front oil
seal and press seal into housing (with seal lip facing inward) until it contacts.
72662
a
a-Front Oil Seal
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General