WALTER V-DRIVE TRANSMISSION SERVICE MANUAL NUMBER 23
Page 8E-6 90-861326--1 MARCH 1999
Installation
1. Slide the over the studs in the adapter housing. The flange may have to be rotated to
align the splines on the adapter flange on the Walter V-Drive transmission and the out-
drive flange on the in-line transmission.
2. Install the nuts and torque to 50 lb. ft. (68 N·m).
75191
a
a-Nuts
3. Connect the wires to the oil pressure switch.
75647
a
b
b
a-Oil Pressure Switch
b-Water Hoses
4. Fill the transmission with the recommended fluid.
Downloaded from https://needmanual.com/!
To Next Page
Loading...
Need help?
General