INSTALLATION
Page 1D-16 90-888438 JUNE 2002
Steering Cable Adjustment
1. Slide bellows assembly over cable and thread on cable completely. Do not tighten.
2. Route cable thru-hull fitting after routing through bellows
54456
3. Thread cable end adaptor on steering cable 14 turns (to allow for adjustment).
WARNING
Cable end adaptor must be installed a minimum of nine (9) turns. Failure to install
cable end adaptor on steering cable a minimum of nine (9) turns could result in loss
of steering control of boat, personal injury, or death.
54902
a
a-Cable End Adaptor
4. Center rudder assembly on nozzle.
5. Center steering wheel by turning wheel lock to lock and positioning wheel midway be-
tween locks.
To Next Page
Loading...
