36
MAINTENANCE
Inspection and Maintenance Schedule
Before Each Race
1. Check that lanyard stop switch stops the engine.
2. Visually inspect the fuel system for deterioration or leaks.
3. Check fuel pressure.
4. Check outboard for tightness on transom.
5. Check steering system for binding or loose components.
6. Check control cable adjustments.
7. Check tightness of bolts, nuts, and other fasteners.
8. Check level and condition of gear case lubricant.
9. Check propeller blades for damage.
10. Check propeller for tightness.
11. Inspect battery.
12. Clean and inspect motor exterior.
AFTER EACH USE OR RACE
1. Flush out the outboard cooling system if operating in salt or pol-
luted water.
2. If operating in salt water, wash off salt deposits and flush propel-
ler and gear case exhaust outlet with fresh water.
EVERY 2 OR 3 RACES
1. Replace 10 micron final fuel filter.
2. Inspect spark plugs.
3. Inspect reeds.
4. Check engine timing setup.
EVERY 25 HOURS OF USE OR ONCE A MONTH
1. Check charging system.
2. Inspect/replace spark plugs if needed.
(continued on next page)
To Next Page
Loading...
Need help?
General
