Mercury VesselView 7 - SmartCraft Network and Data Sources

Section 4 - Setup and Calibrations
Page 30 90-8M0074777 eng MAY 2013
3. Set the tanks' capacity
4. Set various smart contextual limits
5. Turn off or on supported data for each engine
6. Select the number of SmartCraft networks and the network number
The greater‑than sign ( > ) indicates additional menu choices.
SmartCraft
Number of engines > Select 1–4 — —
Depth Offset >
Calibration: offset,
zero, restore
— —
Sea Temperature >
Sea temperature
source >
None, PCM0,
PCM1, PCM2,
PCM3, AirMar0,
AirMar1, AirMar2,
AirMar3
—
Offset >
Calibration: offset,
zero, restore, save
—
Speed >
GPS source > CAN‑P or H —
Pitot speed source
>
None, PCM0,
PCM1, PCM2,
PCM3,
—
Pitot sensor type > 100 or 200 PSI —
Pitot multiplier >
Calibration:
multiplier and
restore, save
—
Paddle speed
source >
None, PCM0,
PCM1, PCM2,
PCM3
—
Paddle speed
sensor >
Legacy or Airmar —
Paddle frequency >
Calibration:
multiplier and
restore, save
—
Steering >
Steering angle
source >
None, PCM0,
PCM1, PCM2,
PCM3, TVM
—
Invert steering
Turn on (check
mark) to invert
steering, or off (no
checkmark), which
engine to show
steering
—
Offset >
Calibration: offset,
zero, restore, save
—
Tanks >
Location: port, port center,
starboard center, starboard >
Tank 1 or 2 > Calibration > Empty, 1/4, ½, 3/4, full
Tank usage >
None, fuel, oil,
water, waste
—
Capacity > 0 up to six digits —