MERITECH CleanTech EVO Wall - Section 4: Maintenance & Components; Cleaning & Maintenance Instructions

To Next Page

To Previous Page

Section 4

Maintenance & Components of this EVO Station

To maintain your EVO stations cleanliness and high-quality handwashing that is expected from a CleanTech

station. We recommend following the cleaning schedule below for

the system. Please note: cleaning instructions for the touchscreen display are on the next page.

Daily Cleaning/Disinfecting:

• Hand wipe external surfaces using a clean, dry non-abrasive cloth to remove dirt or smudges gently. We recommend a Microfiber cleaning cloth.

• If further cleaning is needed, use a commercially available product such as glass cleaner or multi-surface cleaner. Dampen a clean, dry non-abrasive cloth or

use a pre-moistened wipe that is non-abrasive.

• Allow surface to dry.

• Followed by disinfecting per the steps outlined on Page 39of this manual.

Weekly:

• Pour, rub, or spray a bleach, ammonium chloride, hydrogen peroxide, or other hard surface disinfectant into each cylinder to kill any residual pathogens that

may be in the system or facility drain. Always follow manufacturer's instructions on cleaning solutions.

• Clean cylinder surfaces with a cleaning agent that removes mineral deposits. You may use a cleaning brush to assist with cleaning cylinders. Contact

Meritech to get a cylinder cleaning brush.

Quarterly:

• Clean photoeye lens with a clean, dry non-abrasive cloth to remove dirt or smudges gently. We recommend a Microfiber cleaning cloth.

As Needed:

• Replace cylinder every 30K – 50K handwashes or when mineral deposits buildup or water spray pattern or splashout becomes excessive. This service can be

performed by a Meritech Technician.

Cleaning and disinfection are two different steps. Cleaning refers to removing pathogens, dirt, & impurities from surfaces. Disinfecting refers to using chemicals to kill pathogens