XBW Sole Only • 13
Changing Solutions & Re-Priming System
When the Red LED indicator light is flashing and the system alarm is sounding the solutions container needs
to be replaced on the system. Follow the steps below and refer to the photos for replacing the solutions
container and re-priming the system.
1. Remove dip tube assembly attached to the bottle cap with the hose attached from the empty
container.
2. Replace the empty container with a new container of Meritech Boot Cleaner.
3. Drop the dip tube assembly in the new container and screw on the container lid.
4. Hold your hand over one of the systems photoeye’s at the drain end of the system which is the priming
photoeye’s until the system begins to run water and consume soap.
5. Continue covering the Photoeye until the Boot Cleaner fluid is fully primed in the system & the green
LED light is flashing and the brushes are rotating.
Priming Photoeye
note location or drain
end of system
To Next Page
Loading...