XBW Sole Only • 6
Facility Installation Instructions/Requirements
The Boot Scrubber unit requires 120 volt AC, single-phase power with a maximum current draw of 20
amps. Do not hardwire the system electrical cord without having a way to disconnect the system from
electrical source for future serviceability of the system.
The Boot Scrubber system requires a potable water source. Only cold water is required although warm or
hot water can be used as well depending on the types of soils being removed. Do not exceed 110⁰ F water
temperature to prevent scalding. The supply line should supply at least be 4 gallons per minute at 50 PSI
minimum. Do not hard pipe directly to the system as this may prevent future serviceability to the
system. The unit comes from the factory with a ¾” male garden hose fitting for water hook up. The
system requires a floor drain. The sanitizing solution is automatically mixed with the incoming water
supply in the unit and is factory calibrated for 800 parts per million concentration when using Meritech Boot
Cleaner solution. The concentration and water flow rate can be adjusted easily if other settings are desired.
Please contact Meritech to have a qualified Service Technician make the adjustments. For additional
information, see the “Cut Sheet/Specification” of this manual.
Make certain that the system is sitting steady on floor and all 8 feet are touching. Verify that the system is
sloped towards the drain and is ¼ bubble slope and is level side to side per the factory settings.
If these hook-ups are not readily available, you will need to consult with your commercial plumber or
electrician. Because of the different building codes and licensing regulations, Meritech cannot accept
responsibility for providing plumbing and electrical modifications to your facility; however, Meritech will be
happy to provide the necessary guidance to ensure a correct installation.
Consult local and national codes: conformity and compliance to local and national codes is the responsibility
of the installer.
IF YOU SHOULD EXPERIENCE ANY DIFFICULTY OR ARE UNSURE ABOUT THE
INSTALLATION PROCEDURE, WE ENCOURAGE YOU TO CONSULT
IMMEDIATELY WITH MERITECH SYSTEMS, LLC.
Meritech Systems, LLC
720 Corporate Circle, Suite K
Golden, CO 80401 USA
Phone: ( 800) 932-7707
Fax: ( 303) 790-4859
www.meritech.com
E-mail: service@meritech.com
To Next Page
Loading...