XBW Sole Only • 7
Operation
XBW Sole Only
The Meritech Boot Scrubber is easy to operate. As you approach the unit from the Photoeye end of the
system. The Green LED indicator light will be a solid. As you break the Photoeye beam the system will
automatically start. The Green LED indicator light will be flashing. The brushes will begin to rotate and the
sanitizing spray will wash each of the horizontal sole brushes. The system will run for approximately 8 seconds
and then shut off or when the person exits the opposite end. System run time is adjustable. Please contact
Meritech to have a qualified Service Technician make the adjustments.
While using the two side handles for support, walk slowly through the unit allowing time for the sole brush to
adequately clean the bottoms of the shoes or boots. When the entire boot surface is clean simply walk out of
the system. Boot cleaning should take approximately 4 - 8 seconds depending on the soil type. This may take
a few trial cycles to get the right length of time depending on the soil type.
The sanitizing solution is stored in the Blue 20 liter container located on the side of the system. When the
bottle is empty the system will stop rotating, the Red LED light will flash and an audible alarm will beep letting
you know the system needs a new solutions container. For further instructions on changing solutions,
please refer to the “Changing Solutions” in this manual.
CAUTION: This equipment contains moving parts and starts automatically. DO NOT USE with
loose clothing that can be caught in the system. This includes, but is not limited to, long smocks,
frock ties, shoelaces and street shoes.
To Next Page
Loading...