XBW Sole Only • 5
Overview
The Meritech Boot Scrubber provides a means of removing debris and bacteria from the shoes or boots of
your employees. The unit has a series of 2 sole brushes, which scour the soles of the boots. When the
Photoeye beam is broken, the brushes rotate and sanitizing solution is sprayed onto the brush bristles.
As you walk through the Boot Scrubber the boots contact the rotating brushes, which remove the particles
and transfer the sanitizing solution to the boot surface. The drain water and any removed soils or particles are
drained down into the catch basin at the bottom of the unit. The catch basin is sloped side to side and front to
back to keep the water and soils moving towards the drain of the system. The heavier particles may stay in the
catch basin and can be easily removed during shift cleanup. The Boot Scrubber is intended to be used in all
types of environments, bearing in mind that there will be some water that may be splashed out of the system
from use and tracking from the entrance and exit of the system.
Features:
• Sole Scrubbing
• Heavy Gauge 304 Stainless Steel
• 2” MNPT Drain Connection
• ¾” MGH Water Connection
• Bi-Directional Photoeye Operation
• Adjustable Sole Depth
• Ready Indicator Light
• Washing Indicator Light
• Soap Empty Indicator Light
• Soap Empty Audible Alarm
• Tool-Less Brush Removal
• Emergency Stop
• Electrical Disconnect Switch
• On Board 20 Liter Soap Container
• Wash-down Motor and Gearbox
• NEMA 4X Electronics Enclosure
• SLIPNOT® Upper Deck
• Auto shutoff if cover is opened
• 8 Adjustable Equipment Leg
SlipNot® is a registered trademark of SlipNot® Metal Safety Flooring, Detroit Michigan. Copyright W.S. Molnar Company
To Next Page
Loading...