1
0
• Thread one end of the rope through the hole in the top
o
f the red handle so “NOTICE” reads right side up as
shown. Secure with an overhand knot at least 25mm
f
rom the end of the rope to prevent slipping.
• Thread the other end of the rope through the loop of the
manual release cable.
• Adjust the rope length so the handle is no higher than
1
.8m above the floor. Secure with an overhand knot. If
the door is greater than 2.5m in height the release cord
extension kit accessory is required.
N
OTE: Final adjustment of the handle height should be
completed after the opener is installed. If it is
necessary to cut the rope, heat seal the cut end to
prevent unravelling.
11
OPERATING THE MANUAL RELEASE
To disengage the opener
Pull the release cord down once until you hear a
clicking sound. The door is now in manual mode and
may be opened or closed.
To re-engage the opener
Pull the release cord down until you hear a clicking
sound, the motor is now ready for operation.
6
ATTACH THE RELEASE HANDLE AND CORD
Disable all locks and remove any ropes
connected to the garage door.Take care
when operating the manual release as an open
door may fall rapidly due to weak or broken
springs, or being out of balance.
To Next Page
Loading...
