Installation and Operating original instructions.
Part Number 32Z3797 GB
Issue 1
9
PRODUCT DETAILS
A
A
A A
A
A
A
B
B
B
A
A
1
1
1
INSTALLATION
The oven will not operate without the AIR FILTER
correctly tted in place.
Check for obvious signs of transit damage.
If necessary, inform the freight company IMMEDIATELY.
Remove packing material and protective lm from the
oven and safely discard.
Included inside your oven:
Model e3 Series:
Handle. Round Trays (x2) + Square Trays (x2). ●
Pack option: Round Trays (x3) + Teon Matts (x3). ●
Model e4 Series:
Self-supporting Rack ●
Vitreous Enamel Tray ●
Cool down Rack ●
Model e5 Series:
Rack. Vitreous Enamel Trays (x2). ●
OVEN LOCATION AND POSITIONING
Choose a site away from major heat sources.
DO NOT position so that hot air is drawn in from fryers,
grills, griddles, etc.
A heat barrier to the height of the oven must be installed if
sited next to a burner, stove or range.
Place the oven on a permanent nonslip/nonammable at
surface that is LEVEL, STABLE and STRONG enough for the
oven and contents.
Allow a minimum clearance (A) of 2 inches (50mm) around
the oven for hot air to escape.
Allow sucient clearance (B), in front of the oven for the
door to open fully.
The air intake is located at the lower front of the oven
(1) and it is important that the airow is as cool as
possible and not preheated by other appliances such as
burners, stoves, ranges, fryers, grills and griddles as this
will deteriorate the life and performance of the oven.
Do not ax labels/stickers to oven other than those
applied or approved by the manufacturer.
HANDLING & STORAGE:
When moving an oven always observe and follow National
and local requirements for lifting and moving heavy
objects. Do not use the oven door handle to lift oven.
When not in use, electrically disconnect the oven and store
safely in a dry cool place, do not stack ovens.
To Next Page
Loading...
Need help?
General
