Mesa/Boogie TriAxis User Manual

PAGE 23
CONTROLLER ASSIGN SUB - ROUTINE: (Continued)
STEP 2:
Choose a Parameter. Press any left or right arrowed key under a parameter display and you will see the correspond-
ing display window begin to flash. For now (because you are most likely dealing with a new unit that has never been programmed) all
the parameters are set to Controller 00 (PROGRAM/CHANNEL window).
STEP 3:
Choose a Controller. Press the right arrowed key until the window displays the desired Controller number. Press the
PROGRAM left arrowed DECREMENT key if you go past the desired controller.
NOTE: Remember, the flashing window displays the setting of the parameter NOT the controller number. The Controller number
is displayed only in the “PROGRAM / CHANNEL” window. Don’t try to assign the controller to the flashing parameter window by
using the left & right arrowed keys below the parameter window...nothing will happen.
STEP 4:
Press the ENTR key one time. The parameter flashing will stop flashing momentarily and the “Controller” number ap-
pearing in the “PROGRAM WINDOW” will be assigned to this flashing parameter in that preset only.
STEP 5:
Repeat. Follow this same procedure for each parameter that you wish to modulate from Step 2 (do not press the SHIFT
key at this time.) After each parameter/controller assignment, press the ENTR key. Make sure the parameter window stops flash-
ing momentarily, indicating the assignment has been completed. With controllers assigned to all desired parameters, you are now
ready to move to the Value subroutine.
DYNAMIC VOICE PRESENCEMASTERLEAD 2 DRIVE
LEAD 1 DRIVEBASSMIDDLE
TREBLEGAINPROGRAM/CHANNELPRESET
PGM
/CH
COPY
01 2
345678
00
PARAMETER KEYS
FLASH
9
BASSMIDDLETREBLEGAINPROGRAM/CHANNELPRESET
PGM
/CH
COPY
0
1234
5
01
DOWN
UP
FLASH
BASS window display remains
flashing indicating you are
assigning a controller to this
parameter.
BASSMIDDLETREBLEGAINPROGRAM/CHANNELPRESET
PGM
/CH
COPY
01 23 45
01
PRESS ONCE ONLY
ENTR
FLASH
PAUSE IN
NOTICE THE MOMENTARY
PAUSE IN THE FLASHING
PARAMETER WINDOW.
IF YOU ARE NOT SURE
PRESS ENTER AGAIN.

Mesa/Boogie TriAxis Specifications

General

Type	Tube Preamp
MIDI Control	Yes
Tubes	5 x 12AX7
Inputs	1 x Instrument
Effects Loop	Yes
Footswitchable	Yes
Outputs	2 x 1/4" (Main), 1 x 1/4" (Recording)