PAGE 3
TREBLEGAINPROGRAM/CHANNELPRESET
EXIT
ENTR
COPY
01 23
FLASH
PGM
/CH
SHIFT
OOGIE
B
M
ESA
ALL TUBE PREAMPLIFIER
OUTPUT
1 2 3 4
FX LOOP
5
6
7
8
9
10
4
3
2
1
0
A B
MODE
RHY
LD1
LD2
SW
ALL TUBE PREAMPLIFIER
OOGIE
B
M
ESA
DYNAMIC VOICE
PGM
/CH
PROGRAM/CHANNELPRESET
COPY
CHANNEL
NUMBER
FRONT PANEL: (Continued)
COPY FEATURE:
To copy one PRESET to another PRESET location: 1. Choose the PRESET you wish to copy.
2. Press the SHIFT key and then
press key. This “Source” PRESET now
flashes four times.
3. Select the “Destination” PRESET
using numeric keys located below the
GAIN thru LEAD 1 DRIVE windows. You
will now see the Destination PRESET
in the PRESET window.
4. Press the ENTR key one time. The Destination PRESET now flashes indicating that the contents of the Destination PRESET
will be replaced by the “Source” PRESET parameters. (If you want to stop this copy procedure and avoid overwriting the Destination
PRESET, press the EXIT key and return to the “Source” PRESET.)
5. To complete the copy procedure, press the ENTR copy key one more time. The “Source” PRESET is now copied to the Des-
tination PRESET and the PRESET display returns immediately to the “Source” PRESET. If you wish to check your work, toggle
back to the destination PRESET and confirm the parameter values were copied.
MODE SELECTION:
To sequence through the 8 modes, press the MODE key each time to select a new mode.
NOTE: Keep in mind the settings do not change with the MODE key, so if something sounds strange or if no sound is
heard, check Mode/Parameter settings.
THE MODES ARE SHAPED AS FOLLOWS:
Rhy-Green=Vintage Fat Rhythm Lead 1 - Red = Classic British Lead
Rhy-Yellow=Modern Bright Rhy Lead 2 - Green = Mid Gain MK IV Lead
Lead 1-Green=Vintage Mark 1 Lead Lead 2 - Yellow = Classic MKII Lead (MK II-IV)
Lead 1-Yellow=Gain Boost MK I Ld. Lead 2 - Red = Searing MKIII Lead
(For greater detail on individual modes, see the modes section in this manual)
PROGRAM / CHANNEL WINDOW:
Feedback to the user regarding current Midi Program Number or current Midi Channel is
displayed in this window.
NOTE: Remember User PRESETS are not to be confused with Midi Programs. Presets
are created by you (or at the factory) and can then be assigned to a Midi Program number.
In other words; Presets are sounds and Programs are Locations.