Metabo DH330 User Manual

25
ENGLISH
Moisture contents of work piece too
high.
− Dry work piece.
Planed surface cracked
Planer knives blunt.
− Install sharp knives.
Planer knives blocked by chips.
− Remove chips.
Work piece was planed against the
grain.
− Plane work piece in opposite direc-
tion.
Too much material removed in one pass.
− Make several passes at less depth
of cut.
Worked surface uneven:
Planer knives are installed uneven.
− Adjust planer knives with setting
gauge.
Feed rate too little
Resin built-up on bearing surfaces of
centre table, infeed table or outfeed
table.
− Clean bearing surfaces and apply a
light coat of sliding wax.
Work piece jammed
Too much material removed in one pass.
− Make several passes at less depth
of cut.
For special tasks the following accesso-
ries are available at your specialized
dealer – see back cover for illustrations:
A Work Stand
For a secure machine stand and
optimal working height;
folding, ideal for mobile use.
B Dust Extraction Connector
To connect to a dust collector
C Three Roller Support
To support long work pieces
D Planer Knives
For planing wood
E WAXILIT Anti-seize Compound
Sliding wax to improve stock gliding
quality on the planing beds.
F Care and Maintenance Spray
Removes resin residue and pre-
serves metal surfaces
A
Danger!
Repairs to power tools must only be
carried out by qualified electricians!
Electric tools in need of repair can be
sent to the service centre of your coun-
try. Refer to the spare parts list for the
address.
Please attach a description of the fault to
the machine.
10. Available Accessories
11. Repairs

Metabo DH330 Specifications

General

Planing width	330 mm
Maximum planing height	152 mm
Maximum cutting depth	3 mm
Motor power	1800 W
Weight	35 kg
Table length	840 mm
Cutter block diameter	47 mm
Number of blades	2
Cutter block speed	9800 RPM