Metra Electronics 99-3306 - ISO Mount Radio Provision with Pocket

99-3306 KIT ASSEMBLY
3
A
B
C
ISO MOUNT RADIO PROVISION WITH POCKET
Mount the ISO Brackets to the radio
using the screws supplied with the
radio. (Figure A)
1
Slide the radio into the radio opening
until it snaps into place. (Figure B)
2
Snap the ISO Trim Plate onto the front
of the Radio Housing. (Figure B)
3
Snap the pocket into the radio hous-
ing.
(Figure C)
4
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.