Metrohm Titrando 890 User Manual

3.2 Connecting a controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
12
￭￭￭￭￭￭￭￭
890 Titrando
NOTICE
Do not use a not permitted power cord!
1
Plugging in the power cord
￭ Plug the power cord into the instrument's power socket.
￭ Connect the power cord to the power grid.
3.2.1.3 Connecting a computer
The 890 Titrando requires a USB connection to a computer in order to be
able to be controlled by a computer software. Using a 6.2151.000 con-
troller cable, the instrument can be connected directly, either to a USB
socket on a computer, to a connected USB hub or to a different Metrohm
control instrument.
You need administrator rights for the installation of driver software and
control software on your computer.
Cable connection and driver installation
A driver installation is required in order to ensure that the 890 Titrando is
recognized by the computer software. To accomplish this, you must com-
ply with the procedures specified. The following steps are necessary:
1
Install the software
￭ Insert the computer software installation CD and carry out the
installation program directions.
￭ Exit the program if you have started it after the installation.
2
Establishing the cable connections
￭ Connect all peripheral devices to the instrument, see chapter 3.3,
page 14.
￭ Connect the instrument to the power grid if you have not already
done this (see chapter 3.2.1.2, page 11).
The "On" LED on the 890 Titrando is not yet illuminated!
￭ Connect the instrument to a USB connector (type A) of your com-
puter (see manual of your computer). The 6.2151.000 cable is
used for this purpose.

Metrohm Titrando 890 Specifications

General

Brand	Metrohm
Model	Titrando 890
Category	Measuring Instruments
Language	English