Why does my Metrologic MS1690 Focus transmit each character twice?
This issue occurs when the configuration isn't set correctly. To resolve it, increase the interscan code delay setting and adjust whether the F0 break is transmitted. You may need to try this in both settings to find the correct configuration.
What to do if my Metrologic MS1690 Focus Barcode Reader powers up but doesn't beep?
If your Metrologic Barcode Reader powers up but doesn't beep when scanning a barcode, it's likely that the beeper is disabled, and no tone is selected. Enable the beeper and select a tone to fix this.
How to troubleshoot power issues with my Metrologic Barcode Reader?
If your Metrologic Barcode Reader isn't receiving power, check the transformer, outlet, and power strip. Also, ensure the cable is securely plugged into the scanner.
General| Scan Rate | 100 scans per second |
|---|---|
| Scan Speed | Up to 100 scans per second |
| Humidity | 5% to 95% (non-condensing) |
| Connectivity | USB, RS-232, Keyboard Wedge |
| Light Source | Visible Laser Diode 650 nm ± 10 nm |
| Decode Capability | UPC/EAN/JAN, Code 39, Code 128, EAN 128, Interleaved 2 of 5, Discrete 2 of 5, Code 93, Codabar, MSI, Code 11, Bookland EAN, Trioptic Code, Coupon Code, TLC39, RSS variants |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Light Levels | 0 to 100, 000 Lux |
| Resolution | 0.127 mm (5 mil) |
| Drop Specification | 1.5 m drop to concrete |
| Supported Barcodes | UPC, EAN, Code 39, Code 128, Code 93, Codabar, Interleaved 2 of 5 |
| Type | Handheld Barcode Scanner |
To Next Page
