MDE-4631 Metrologic® MS7120 Bar Code Scanner Setup · January 2007 Page 1
Introduction
Purpose
This document contains a verification sequence that allows you to determine whether your
scanner is configured correctly, and a programming sequence to follow if it is not configured
correctly.
Be aware of the following:
• Refer to MDE-4389 Setting Up Datalogic™ DLL2020 Bar Code Scanner Used on
Profit Point Terminal for Datalogic DLL2020 scanners.
• Refer to MDE-4354 Setting Up Metrologic
®
MS6720 Bar Code Scanner for
Metrologic MS6720 scanners.
IMPORTANT INFORMATION
Note: Your bar code scanner has been programmed with default settings at the factory and
should be ready to be configured.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 3
Setting Up the Scanner 5
Programming a Sequence 7
Bar Codes 8
MDE-4631
Metrologic
®
MS7120 Bar Code Scanner Setup
January 2007
To Next Page
Need help?
General
