Metrologic MS7120 User Manual

MDE-4631 Metrologic® MS7120 Bar Code Scanner Setup · January 2007 Page 1
Introduction
Purpose
This document contains a verification sequence that allows you to determine whether your
scanner is configured correctly, and a programming sequence to follow if it is not configured
correctly.
Be aware of the following:
• Refer to MDE-4389 Setting Up Datalogic™ DLL2020 Bar Code Scanner Used on
Profit Point Terminal for Datalogic DLL2020 scanners.
• Refer to MDE-4354 Setting Up Metrologic
®
MS6720 Bar Code Scanner for
Metrologic MS6720 scanners.
IMPORTANT INFORMATION
Note: Your bar code scanner has been programmed with default settings at the factory and
should be ready to be configured.
Table of Contents
Topic Page
Introduction 1
Important Safety Information 3
Setting Up the Scanner 5
Programming a Sequence 7
Bar Codes 8
MDE-4631
Metrologic
®
MS7120 Bar Code Scanner Setup
January 2007

Metrologic MS7120 Specifications

General

Brand	Metrologic
Model	MS7120
Category	Barcode Reader
Language	English

Summary

Introduction and Purpose

Scanner Setup Purpose

Explains the document's goal to verify and program the scanner for correct configuration.

Warranty Information

Important Safety Information

General Safety Precautions

Covers preliminary precautions, electrical shut-off, working with fuels, and safety symbols.

Specific Safety Hazards

Details hazards like open flames, sparks, electricity, and hazardous materials.

Emergency Procedures

Provides guidance on emergency first aid and lockout/tagout procedures for safety.

Setting Up and Verifying the Scanner

Performing the Verification Sequence

Details how to verify correct scanner programming by scanning an item and checking the display.

Programming a Sequence

Bar Codes for Configuration