B - Automatic channel shearch
• Go to MENU / Installation / Auto Scan
• On the line Satellite, select with 34 arrow keys the satellite that broadcasts the channel
you want to add
• On the line TP Freq, press OK to access to the list of transponders (TP).
• Check that the Quality is higher than 40%. If not, it means that the LNB settings might be
wrong, or that you are not on the correct satellite.
• On the line Scan Mode, choose FTA Only in order not to fill the channel list with encrypted
channels that you may not view. On the line Network Search, keep OFF.
• Press on the red key (back arrow) to launch the search
• A windows opens, listing the new channels found.
• When the scan is over, press OK to store the new channels at the end of the channel list.
Press EXIT to exit all menus.
C - Channel shearch by scan
The scanner is a powerful feature that allows to find channels, even though you don’t know their
frequency. This is especially useful in a communal building where the satellite signal has been
converted in unknown frequency.
• Go to MENU / Installation / Auto Scan
• On the line Satellite, select with 34 arrow keys the satellite that broadcasts the channel
you want to add
• Press on the black key (MOT)
• The default symbol rate (SR) range is 1000-45000 MS/s. You can reduce this range (10000-
30000 for example) to speed up the search.
• On the line Polarisation, leave H/V
• Press on the red key (back arrow) to launch the search
• A windows opens, listing the new channels found.
When the scan is over, press OK to store the new channels at the end of the channel list. Press
EXIT to exit all menus.
To Next Page
Loading...
