Meyer ELECTRO LIFT E-47 - SNOW PLOW WILL NOT ANGLE RIGHT

-28-
Replace both the
Coupler sets and/or
clean or replace the
"C" Valve.
SN
O
W PL
O
W WILL N
O
T ANGLE RIGHT
Can the snow plow
Raise?
See the Raise
Flow Chart
Section
NO
NO
NO
YES
YES
NO
Is there power to
the motor solenoid?
(White Wire)
Is there power
leaving the switch?
Are the wires in
molded connector
making contact with
the switch?
Are "C" Valve
O-Rings in good
condition?
Replace the
"C" Coil.
Retest
Replace
O-Rings
Replace the
P.A. Block
YES
Does the motor run
when angle switch
is pushed?
NO
Replace Harness
Replace Angle
Switch
Can the snow plow
angle to the Left?
Does the snow plow
raise instead of
angling left?
NO
NO
Does the "C" Coil
have magnetism?
(Green Wire)
Is there power to
the "C" Coil?
(Green wire at harness)
Clean or replace the
"B" Valve.
Retest
NO
YES
Clean or replace
the Crossover Relief.
Does the snow plow
now angle?
YES
YES
YES
NO
NO
Is there power
leaving the switch?
Are the wires in
molded connector
making contact with
the switch?
Replace Angle
Switch
YES
Replace Harness
YES
YES
YES